- No products in the basket.
Yes: see our range of polyurethane pigments
Yes
see J Foam 3106 and J Foam 3087
Check each Technical
Specification for skinning properties
Density can be varied by increasing/decreasing the pressure in the mould.
We would always recommend small vent holes are a requisite part of the mould. Pe
A GRP mould generally will work best: see our range of polyester resins etc.
We would recommend J Wax in either liquid or aerosol, depending on surface coverage required.
Each foam will vary :
please check the Technical Data for each foam to ensure the recommended mix is
obtained.
We would not recommend it as the foams properties will be impaired -
